Results 1 to 1 of 1
-
05-24-2023, 02:41 AM #1
Repetier Host and object placement
Morning allBit of a newbie question here.SystemMac Pro 5.1 running OS MojaveLatest Repetier that will run on my Mac 1.2.1(106)Slic3r as installed with Mac Repetier 1.3.1 devGeetech i3 C pro with Firmware I3proC_V1.0.05.hex from the Geetech siteWhen I import an STL in to Repeater, it sits square on the platform, nicely centered.Slicing tab then shows the item off to one side to the right.When printing , it sits almost correct on the bed, but not quite.Not sure where to start all bed settings seem correct, but I am guessing not.I did try a standalone Slic3r version 1.3.0 and that gives the same result.Any help on where to start appreciated.Even if I can go to a later firmware than the geetech firmware ..I see talk of Marlin firmware ..is there perhaps a later version that might be better?Sorry maybe very basic question, but my last printer was MakerBot with all bundled software and no need for this hassle...it just worked...Thank you
Ender 3v2 poor printing quality
10-28-2024, 09:08 AM in Tips, Tricks and Tech Help