Results 1 to 1 of 1
-
05-23-2021, 10:21 PM #1
- Join Date
- May 2021
- Posts
- 1
Print Crash....Z movement stopping about 75% up and pushing print off bed
So i had multiple prints of various heights where the z axis movement appears to stop and the extruder just clashes with the print and actually pops / pushes the magnetic bed and print off the printer and then just runs out a birds nest. Any suggestions of fault finding please? i may start with a tall tower print to see if the z-stepper or screw-rod is at fault.
Screenshot_2.jpg
Resin has changed after...
06-18-2024, 10:34 AM in General 3D Printing Discussion