Results 1 to 4 of 4
-
03-11-2021, 06:54 AM #1
- Join Date
- Mar 2021
- Posts
- 2
Flashforge settings for printing dices?
Hi!Can anyone advice me on which settings I should use for this print, especially support settings to make the dices as accurate as possible!i also wonder how to get a smooth surface underneath a flat print? My prints are coming out with kind of "tready" surface when I remove it from the raft, but the raft surface is as smooth as it could be!!!Hope anyone can help me...?CamillaGT86
-
03-11-2021, 07:09 AM #2
well to start with you should not need supports OR a raft.
what surface do you have on your printbed ?
-
03-12-2021, 03:35 AM #3
- Join Date
- Mar 2021
- Posts
- 2
I use autosuppert and they come up. I tried to print without supports with one side of the dice facing flat down, but then that surface got totally different than the other sides...
I print on the plate that came with my Flashforge Adventurer 3... And I use Dimafix glue.
I thought that I always shoud use raft?
-
03-12-2021, 06:52 PM #4
A 2 or 3 layer brim should do it.
Qidi X Plus 3 Paper thin first...
Yesterday, 01:15 AM in General 3D Printing Discussion