Results 1 to 4 of 4
Thread: Top of print , quality
-
07-30-2020, 08:43 AM #1
- Join Date
- Jul 2020
- Posts
- 14
Top of print , quality
Ender 3
How to get better top surface quality , what is the problem here ?
Temp nozzle 200
Profile 0.28
-
07-30-2020, 12:38 PM #2
- Join Date
- May 2018
- Posts
- 578
sand paper.. This is not injection molding.. that look rather good, top is never smooth like bottom. You may want to reduce the extrusion multiplier by .01 or .02, looks a little over extruded
-
07-30-2020, 03:40 PM #3
- Join Date
- Jul 2020
- Posts
- 14
Thank You
-
08-08-2020, 08:52 AM #4
- Join Date
- Jul 2020
- Posts
- 12
Hi DavaX,
If you use Cura you can switch on "Ironing" in the settings.
It makes the nozzle go over the top layer again with very little filament extruded.
On the negative side it adds to the print time.
Hope this helps,
Andy
Printing time- Is this right?
09-13-2024, 07:51 AM in General 3D Printing Discussion