Simplify3D with FlashForge

[34Ford]

I loved that too...which is why I do a couple rounds of a skirt. Gets rid of any hangies.

After hours of trying different codes I did get simplify to do a pool in the corner and lay down a line to the part, but only for the one part.
Problem is, simplify puts in its code after the initial start code which kills the code I put in the start code. Doh!

So I went in and deleted the purge, and like you, I just let it do a skirt to get the flow we need.

[AmyInNH]

After hours of trying different codes I did get simplify to do a pool in the corner and lay down a line to the part, but only for the one part.
Problem is, simplify puts in its code after the initial start code which kills the code I put in the start code. Doh!

So I went in and deleted the purge, and like you, I just let it do a skirt to get the flow we need.

If you want it to save your changes to the profile so it'll do that same purge every time, you'd have to select "Update Profile", near the top.