Results 1 to 10 of 85
Thread: Simplify3D with FlashForge
Threaded View
-
09-08-2015, 09:39 AM #23
I love this too...
I need to find what the gcode is to get that back in Simplify3D... I still have not started using it (bought it on Sep 5th)... still using ReplicatorG
I have been reading the manual... and reading the tips on the forum. Learned to day that I can remove/modify the amount and location of the supports. This is great.
I need to get off my as* and get the darn software configure/fine-tuned to my printer. Default settings were definitely not optimal... reason why I went back to ReplicatorG to finish what I was doing. And also, doing this at 3am is not the best time to think clearly, lol.
Qidi X Plus 3 Paper thin first...
05-27-2024, 01:15 AM in General 3D Printing Discussion