Quote Originally Posted by sasabs View Post
Yes, S3d does have ts faults, the chief one being lack of good doumentation. understandable for free stuff but unacceptable at $140.
It is my primary slicer though. As Mr. Aardvark says, Once you have it set up it stays setup. S3D support has been very helpful.
Sometimes I still use MW though for very simple prints, and for some iinvolved dual extruder prints because MW will automatically line up both files which is very time consuming manually.
S3D Will line up duel extruder very quick if the model is done correctly. All you do is load each part of the model hold down the shift key and click the center button and it lines everything up.

Also S3D Support forum is a good source of information the are 22 tip of the day post explaining all the functions in each tab.
http://www.forum.simplify3d.com/view...fe6b92c5ac3e16