Results 1 to 10 of 33
Thread: Desperate for bed adhesion !!!!
Hybrid View
-
01-20-2015, 03:38 PM #1
- Join Date
- Jan 2015
- Posts
- 445
not the best pic, but here it is.
I watched the entire first layer go down and it was perfect... as good as ive seen/done.
Its actually pulling away from the brim.
Crazy thing is, this PEI i print on (its amazing btw, like REALLY amazing). holds this part so hard, that i have to level the bed every print... I is insanely hard to get off , but corners once in a while pop.
-
01-20-2015, 04:51 PM #2
- Join Date
- Jan 2015
- Posts
- 445
as the print goes on, its pulling away slowly a little bit more.. only this corner though...
New to 3d printing looking for...
05-20-2024, 12:56 AM in Tips, Tricks and Tech Help