Weird alignment at end of print

[GamerDarling]

In the setup manual it told me to use a feedrate of 60 and a travel feedrate of 80. Acceleration is also turned on on the printer itself. Are the other speed settings that I should be aware of?

[jfkansas]

Nope, should be good there.

[GamerDarling]

I think you saw on the google forum that I am getting successful prints if I lower it to 50 and 70. I'll try 60 and 60 and see what happens. The key print was failing consistently before, so you'll hear back shortly.

[GamerDarling]

I've been a slacker. 60 and 60 also seems to print just fine though! So long as it's not too much detail/high res.