Best practice with ABS: no delamination, no cracking, no warping.

[usarmyaircav]

thanks for the info! ill try bumping up my extruder temp . in addition im having very good bed adhesion with an PEI sheet over my glass . it sticks so well that you can not even take off the printed part until it cools below 60c . and the best part is you dont need to add anything . no spray , slurry or tape .

Pichuete, how did you attach the PEI sheet to your glass?

[pichuete]

i used 3m adhesive transfer tape 468m , its as thing as a sheet of paper and transfer heat well . they sell it in different sizes in my case i used the 0.5 in and apply but if ill do it again i would buy 1 in . to cover the glass . they also sell a 12x12 sheet of this tape but i think it will be harder to work with this thing is very sticky