Results 1 to 3 of 3
Thread: Test cube problem
-
12-23-2014, 09:55 PM #1
- Join Date
- Dec 2014
- Posts
- 12
Test cube problem
hello everyone
I just got my first 3d printer and I'm having trouble printing test cubes, the top of the cube always has holes in it
20141223_224550.jpg
any idea how to fix this?
-
12-23-2014, 10:31 PM #2
#1, test cubes should always be printed 100% solid. There is no real reason to deviate from this. Most likely those were printed without enough support and the top sagged.
Print a cube at 100% infill, .2mm layer height, 60mm/s feed rate, 100mm/s travel. 235 temp for abs, 200ish for PLA.
Then snap a picture of it.
-
12-23-2014, 11:17 PM #3
- Join Date
- Dec 2014
- Posts
- 12
20141224_000735.jpg
It turned out better, thank you
My 3D Norn Emissary print
09-13-2024, 02:28 AM in 3D Printing Gallery