Rambo Servo Setup for Auto Bed Leveling for Noobs

[adamfilip]

hmm adding the decimal place seemed to make the hotend closer and it was worse. not sure what i should be adjusting at this point.

[sniffle]

hmm adding the decimal place seemed to make the hotend closer and it was worse. not sure what i should be adjusting at this point.

-10 to -10.4 is more negative and closer to the bed, try backing it off to -9.5 that's .9 further above the bed than -10.4

[adamfilip]

Thats what I ended up doing.. thanks!

[sniffle]

no problem, i actually had work to do at work so my reply was slow

[adamfilip]

for anyone interested this is my current config.h file for my i3v 12" with RAMBO

Configuration.h

[adamfilip]

Thanks again, my success rate for printing, as increased dramatically. I love ABL lol!

[sniffle]

i'm the same as you :-) and no problem. I see us as a community and communities help each other

[beerdart]

Any fix for this?

I keep getting a Endstop hits Z, message when im trying to manually control z height, and its not hitting anything

[sniffle]

Any fix for this?

you have to disable software min endstop

[beerdart]

Could you please be more specific?

you have to disable software min endstop