Oh, right. It's a Solidoodle 4. I reflashed with what I think I was told is the official firmware. http://support.solidoodle.com/hc/en-...e-Source-Files

The configurations? Well it gets removed. But I hadn't modified it.
As for slicer and program settings, well they are stored in the PC so no change was done on those.

Pics:
http://www.thingiverse.com/thing:79737







Happens both with prints with very wide bottoms as well as thin ones (like in the last pic, which is printed halfway). Both small (few cm) and big (10cm+)
The parts that do not warp are attached to the bed pretty strongly.

(And the black stuff on the prints are grease (got on it later))