Results 1 to 10 of 20
Thread: Advice on my watercooling setup
Threaded View
-
12-16-2014, 05:15 PM #18
- Join Date
- Jun 2014
- Location
- Burnley, UK
- Posts
- 1,662
Speaking from experience. I have only printed PLA once and it was with the Stratasys. I bought 25 metres just to see if it would print OK. I don't use PLA as I prefer ABS but had to try it.
The bed is heated by the chamber. It is not possible to have a cold bed and a heated chamber unless you have refrigeration plant on the bed.
Suggest you buy a Stratasys and try it.
A significant number of people use PLA in place of the Stratasys support material as it is cheap and will dissolve in D-limonene.
Please explain to me how to...
Yesterday, 12:15 PM in 3D Printer Parts, Filament & Materials