Results 1 to 3 of 3
Thread: Taulman bridge problems
Threaded View
-
12-06-2014, 07:30 PM #1
- Join Date
- Nov 2014
- Posts
- 35
Taulman bridge problems
Trying to print some bridge material on FlashForge creator pro....
Haven't even got past loading it yet....
temps tried were anywhere from 235-265, all the same result....the filament flows freely at times, and then every 5 seconds or so the extruder clicks, and the filament then comes out for about a foot as shown...
IMG_2187.jpg
This is from 2 different rolls of bridge, both came out immediately (5 minutes before) from their sealed bags, and I live in a very dry climate.
I did have some flexible TPU in that extruder just before....but I loaded the bridge at up to 265 with at least 6 meters of material coming out of the nozzle, so you would think the TPU would be gone.
I mic'd the diameter and all though 2 of the 3 rolls were out of spec (1.85mm) the in spec roll still had the exact same problems
Anybody know what is going on? I have heard nothing but good things about this stuff.
Ender 3 Neo - Jam Problem
05-08-2024, 03:06 PM in Tips, Tricks and Tech Help