Results 1 to 10 of 10
Thread: Snap sound during print
Threaded View
-
12-02-2014, 12:51 AM #2
- Join Date
- Nov 2014
- Posts
- 35
I played with it in jog mode and found 2 spots along the z axis that make this snapping sound.
they only make the sound from a dead stop....it's fairly hard to find in jog mode causing me to believe the spot is very small. One locations is much louder then the other, and they are 100% repeatable (if you hit the jog at the right spot)
i was was thingking a stepper gear, but that doesn't make sense because the stepper would rotate dozens of times over the z axis travel.....then the snap should happen in dozens of places, but so far only in 2 spots
Please explain to me how to...
Yesterday, 12:15 PM in 3D Printer Parts, Filament & Materials