Results 1 to 10 of 72
Thread: OpenScad Help Centre
Threaded View
-
12-08-2014, 05:42 AM #26
yep the $fn= command is the 'number of facets' command. Hence the 'facet command' :-)
And yes I am definitely a pheasant pluckers son. My dad was a poacher way back when I was a wee sprog (and we are talking a long long time ago). Only way we could afford regular meat.
You'll never get a shine on that duck doing it that way. Your buffing wheel needs to go faster and use some polishing wax.
Apparently you melt a bucket of wax, dip the bird in, wait till it sets and then peel it off with all the feathers.
Quite where you buy bucket loads of wax from - not a clue.
We'll see how the mkII de-featherer works when i finally get a chance to make it.
cube (32,32,20);
is the same as
cube (32);
and is a cube
cube ([32,32,20]);
Is not a cube it is a rectangular cuboid.
I have to admit I never do the shortcut method. Always type the full ([0,0,0]) in before I add the numbers.Last edited by curious aardvark; 12-08-2014 at 05:48 AM.
Please explain to me how to...
Today, 12:15 PM in 3D Printer Parts, Filament & Materials