Results 1 to 4 of 4
Thread: Going below zero
Threaded View
-
12-02-2014, 11:05 AM #4
- Extruder jams that I've experienced are normally due to inconsistent filament size. If your feeding more material into the 'Hot End' than it can extrude successfully it starts to create a back up pressure that eventually jams the extruder.
Suggested test:
- On a few pieces try dialing the flow-rate down or increasing the filament size parameter a bit and see if that begins to alleviate the jamming.
Please explain to me how to...
05-17-2024, 12:15 PM in 3D Printer Parts, Filament & Materials