NEW Printrbot Metal PLUS

[LambdaFF]

Well
Some news. First the heating : Printrbot is retrofitting the Metal Plus with Heat Bed by sending an insulating kit for free. Should help for ABS. I haven't tried it yet, some users seemed concerned.

I wanted to try that 3ple gear stand from Henry Segerman. Result was quite good for a first try. I think. Anyway I'm thrilled. Only pblm : my spool stands don't work with the spool I'm using. I've had to put the bearings on the outside of the support I have. I'm working on a more permanent design. I'll post if if it works.

[LambdaFF]

It works !