I ordered the new Prusa i3v 12" today. With the build volume of 12" x 12" x 13.5" and layer thickness of 50 microns it appears to be the best printer for the price.
And the support from Makerfarm is terrific. Any suggestions for a hotend?
I purchased the Hexagon 1.75 with a .3mm nozzle. Later may go to dual nozzles and upgrade to E3D V6 or Prometheus V 1.1.

Should I seal the Baltic Birch frame or leave it natural. We are 1 mile from the Merrimack River and twenty miles from the Atlantic so it gets humid here in the Summer and the Winters are very dry. I was planning on using a seal/stain product from Minwax.