Results 1 to 7 of 7
Thread: Repetier Host NEW version 0.95
Hybrid View
-
01-15-2014, 11:30 PM #1
The randomize starting point is an option especialy made for bowden systems(but that can be used also for direct extrusion), it's made to prevent oozing. I don't think that it's an important option for the SD because it's a direct extrusion.
If you're having ooze at the starting point you may change the retraction option inside slicer. Each time the hot end will start a layer it will make a little retraction so you won't have this "tear"(ooze) !
Here is some informartion about how "fighting" against oozing problems:
http://manual.slic3r.org/FightingOoze.htmlLast edited by Mcbride19; 01-15-2014 at 11:48 PM.
Please explain to me how to...
Yesterday, 03:08 PM in 3D Printer Parts, Filament & Materials