Prusa mendal I2 Pronteer face Marlin error

[jakers181008]

Hi after going to the shops to replace the 9V battery in my multi-meter, i had found out my Y board for the stepper wasn't actually showing any side on fife, nut lucky i had a spare one that would of been used for my second extruder (If i had on) but they are now all set to the correct voltage as per the manual says.


I will update my marlin software on here just in case i've done something wrong..... :/ still no reply from the seller of the LCD board, not important as of yet as am currently using laptop to control the board mainly, just using the board to see the temps

my marlin.zip