Subscribe to Our Newsletter Advertise
Close



Results 1 to 4 of 4

Threaded View

  1. 11-05-2014, 07:08 AM #4
    Marm
    Marm is offline
    Engineer Marm's Avatar
    Join Date
    Sep 2014
    Posts
    629
    Add Marm on Thingiverse
    Ok.... Can't adjust Temperature, and can't do PLA.

    My thought process was that at a higher speed, the previous layer would have less time to cool off, and as these have been fairly sizable builds, any one particular location would have a lot of time to cool down.

    I'll have to do a couple test builds to see. I will try both high and slow speed.
    Last edited by Marm; 11-05-2014 at 07:21 AM.
    Reply With Quote Reply With Quote
« Previous Thread | Next Thread »

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  

Forum Rules