Results 1 to 4 of 4
Thread: Delamination, again.
Hybrid View
-
11-05-2014, 07:08 AM #1
Ok.... Can't adjust Temperature, and can't do PLA.
My thought process was that at a higher speed, the previous layer would have less time to cool off, and as these have been fairly sizable builds, any one particular location would have a lot of time to cool down.
I'll have to do a couple test builds to see. I will try both high and slow speed.Last edited by Marm; 11-05-2014 at 07:21 AM.
Please explain to me how to...
05-17-2024, 12:15 PM in 3D Printer Parts, Filament & Materials