Results 1 to 3 of 3
Thread: Heatbed Relay Melted
Threaded View
-
12-06-2014, 09:59 AM #1
- Join Date
- Sep 2014
- Posts
- 3
Heatbed Relay Melted
For the last couple of prints I noticed a strange burning smell from my printer. The printer was functioning fine so I wrote it off as the filament I was using. However this morning I started a print and the smell was stronger. I looked all around and noticed the heatbed relay had melted and there was a small amount of smoke coming from it. The printer was still functioning fine.
I turned off the printer immediately.
Anyway, I was wondering if I can just throw a new headbed relay in there which is relatively inexpensive... Or was this caused by a bigger problem? Here are some pictures.
IMG_0252.jpg
IMG_0253.jpg
Ender 3 Neo - Jam Problem
05-08-2024, 03:06 PM in Tips, Tricks and Tech Help