Subscribe to Our Newsletter Advertise
Close



Results 1 to 10 of 112

Hybrid View

  1. 11-07-2014, 08:23 PM #1
    MiniMadRyan
    MiniMadRyan is offline
    Engineer-in-Training
    Join Date
    Jul 2014
    Location
    Ontario, Canada
    Posts
    257
    Hmm.... so is it something in my Repetier then?... auto homing from the LCD panel works perfectly fine. Goes to 0,0 then returns to Centre and probes the 7

    I haven't changed any settings on RH in ages... it's printed perfectly for my MakerFarm, and Printrbot too....
    Reply With Quote Reply With Quote
  2. 11-07-2014, 09:52 PM #2
    Roxy
    Roxy is offline
    Super Moderator Roxy's Avatar
    Join Date
    Apr 2014
    Location
    Lone Star State
    Posts
    2,182
    Quote Originally Posted by MiniMadRyan View Post
    Hmm.... so is it something in my Repetier then?... auto homing from the LCD panel works perfectly fine. Goes to 0,0 then returns to Centre and probes the 7

    I haven't changed any settings on RH in ages... it's printed perfectly for my MakerFarm, and Printrbot too....
    I doubt this is being caused by Repetier... But I don't use it. Would you mind switching to PronterFace until we get this resolved? I have never seen this kind of weird behavior and it might be best to remove any variable we can. With that said... Once we start running the debugging version of the code, we are going to be able to figure out what is causing the bad code paths to be taken.
    Reply With Quote Reply With Quote
« Previous Thread | Next Thread »

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  

Forum Rules