Saving G29 Bed Level Correction Matrix to EEPROM

[Roxy]

Roxy, I ran into an error adding your code:

ConfigurationStore.cpp: In function ‘void Config_PrintSettings()’:
ConfigurationStore.cpp:129:65: error: void value not ignored as it ought to be
plan_bed_level_matrix.debug("\n\nBed Level Correction Matrix:")
^ (this caret should be under the closing parenthesis after "Matrix")

That is the only error. Commenting out only the added code block from Config_PrintSettings let it compile cleanly.

It's fixed now. Somehow during the Cut & Paste I didn't get the very last character of the line (which was a semi-colon. The compiler knows it is missing a semi-colon, can't it just put it in there for me???

Any way, if you go add the semi-colon it should compile clean and let you print out the Bed Level Correction Matrix. I'm not sure how the output is going to look because I can't run any of this code yet to test it.

AbuMaia, does the code behave as expected and do what people wanted? Can you add the semi-colon and invoke the EEPROM Print so we can check if the matrix prints OK ?