Saving G29 Bed Level Correction Matrix to EEPROM

[Roxy]

So you think nobody should ever use this code?

No, of course not. (If this was directed at me???) I just don't know that I'm going to use it much because my printer isn't good enough to hold super tight tolerances across a big range of temperatures. But some people really do have machines that can benefit from this.

[DarkAlchemist]

No, of course not. (If this was directed at me???) I just don't know that I'm going to use it much because my printer isn't good enough to hold super tight tolerances across a big range of temperatures. But some people really do have machines that can benefit from this.

Exactly what I was getting at, or trying to say, AbuMaia.

For most people, not the lucky few, this routine will mean they can print in multiple colors in one session with a single extruder but once that printer cools down and you have to reheat it those people, the majority of the people that includes me, and apparently Roxy is among us, we *must* reissue the G28/G29 again.