Results 1 to 10 of 35
Hybrid View
-
10-31-2014, 01:10 PM #1
I'm trying to find some good settings (will update later this weekend) but I was wondering if I could calculate 'perfect' settings based on the hardware.
So perhaps Mjolinor knows this one ('cause you seem to know a lot of this technical mumbo-jumbo)
How often per second does the motherboard / controller talk to the stepper motors?
What's the smallest step the steppers can make the extruder move in X Y directions?
What's the smallest length of material that can be extruded in one step?
I'm thinking I could use that to calculate which values allow for no floating point values going to the stepper which perhaps allows some small improvements?
New to 3d printing looking for...
05-20-2024, 12:56 AM in Tips, Tricks and Tech Help