Results 1 to 10 of 15
Hybrid View
-
12-04-2014, 08:55 AM #1
The communication link is a weak component of the design. It is across USB, but that USB port is pretending to be an RS-232 communication port. And the protocol for detecting errors in transmission of a line of GCode is pretty lame. I think it is fairly possible the communications to the printer is at fault as opposed to the actual printing being to blame. So, I'm in agreement with printing from and SD-Card for a while. If that goes OK and you switch back to using an USB cable and things start locking up again... You might have your answer.
New to 3d printing looking for...
05-20-2024, 12:56 AM in Tips, Tricks and Tech Help