Results 1 to 10 of 15
Hybrid View
-
10-17-2014, 03:45 PM #1
- Join Date
- Oct 2014
- Posts
- 2
Thanks, I didn't realize there was a difference. I'll give it a try and see if it prints.
-
12-04-2014, 09:50 PM #2
I don't have a USB port on the front face of my computer. Mine's around the back, If the port was in front, I'd run the cable from there, tie wrap the small plug to the controller board somehow and when I wanted to disconnect, I'd remove the big flat connector from the front.
It is a shame that one can't 'power off' the board with disconnecting it. An inline switch would be nice and make things tidy.
As for the width of the tape - I only needed microfibre. Boom Boom rim shot.
OME
Please explain to me how to...
05-17-2024, 12:15 PM in 3D Printer Parts, Filament & Materials