If you've checked my recent posts, I've been having trouble with filament recently. I finally fixed the issue and printed off some quadcopter pieces. I noticed the next morning that they had layer separation on them, which was weird being that they were in a small, closed space (better environmental heat) and they were short (better inner heat). When I tried heating up my bed for tonight's prints, it wouldn't heat. The screw-down connectors for my bed are melted. The board has burn marks on it and the connector is done. I can't think of what to do next other than buy a new board or find a way to run the bed off of D09.

Any tips?
Photo Oct 14, 12 08 28 AM.jpg