Glass Bed, What and Where would you get one?

[jdg56]

Are these clipped-on plates easy to take out an put in the freezer, and put back in, without re-levelling?

I do that, recently. I have 2 1/8" glass beds, which I use for ABS and PLA. I level when I switch between them, and once a week otherwise, but I remove the plates often to wash them, re-apply my glue | hairspray, and find the level to be good on re-installation.

The ABS plate goes in the freezer more often than not. For some reason, now that the weather is cooling off, my ABS-and-purple-glue prints stick like maniacs.

Cheers,

John