Results 1 to 10 of 112
Threaded View
-
10-14-2014, 03:19 PM #11
Best tip in this whole thread right there!
hahaha, I wanted to try it, but was too afraid of the end result, now I am happy I didn't try it!
Ah, I get what you mean! No, that is not in the software. You'd need to measure it in your CAD/modeling software and do some calculating I'm afraid!
Just remembered another tip:
BE CAREFUL WHEN USING CONCENTRIC EXTERNAL FILL PATTERN!
Only do this at very slow speeds, because it will shake your machine apart when it comes to the small diameter circles.
Does anybody know any sort of scripts which are interesting?
I wish there was an option to have more control over the shells: speed control per shell (not just outer shell), tool control (different material per shell)
New to 3d printing looking for...
Yesterday, 12:56 AM in Tips, Tricks and Tech Help