Okay there are a an increasing number of us makerbot clone users getting this software. Figured we could use a thread to pool settings, tips, work rounds etc.

My first question - how do you stop it spitting a length of filament into the case before a print ?

It's obviously the equivalent of makerwares sticking a length to the bed - which i prefer as that seems to collect any bits.

So is it changeable at all ?

So first interesting thing.

I'm currently printing a peice with a bit of overhang that was warping a lot with makerware. Same p[art isn't warping at all with simplify.
Only thing I can think of as the temp settings are the same is the type of infill.
Honeycomb on mw and linear on s3d.
I did knock a few mm off the length of the overhang - but that by itself wouldn't make the difference I'm currently seeing.

Ah - forgot to set the layer to 0.3 - it's doing this one at 0.2 - that would probably make the difference.