3D Printed Lion Stop Frame Film

[Geoff]

It was cool with the polar bear because it interacted with the stairs, this is really easy to do yourself.

If anyone has poser, Blender, 3DSmax or really any 3D animation program, you can export single frame meshes of the animations. So you simply go to frame 1,. Export all body parts, weld at seams and export to OBJ.

Then you go to frame 2, and you do the same, until you have finished the run cycle.

What's less impressive, is they used a central beam to keep the cat upright, rather than actually glueing or printing it out on a base, which would look much better. That tail would have needed supports, so why not print on a base with supports.