[Work In Progress] T-rex skull

[curious aardvark]

Very Nice indeed :-)
what infill level did you use ?

So did you use supports for that or not ?
(looks at thingiverse file)

No supports.

Might give that a go but at 0.3 mm and probably reduced size as well :-)

Have to say there were a few of those skulls at the show yesterday - and yours is easily as good as any of them. And some of them were made on machines costing £50,000 plus !

Right going for about a 70% scale t-rex skull at 0.2 in abs.
Added all four pieces to the bed and scaled till they just fit.

No more bulldog clips so i can happily use the whole bed.

I'll run it overnight from the sd-card.