Marlin firmware fork for MakerFarm i3v w/ auto bed level & Roxy's enhancements

[tsteever]

Man, not sure I should have opened this can of worms. It was working fine before.

I went to check the servo angles and now it won't home. I am getting the following error...

Error:MINTEMP triggered, system stopped! Heater_ID: 0
Error:Printer halted. kill() called!

10 minutes later and i can get it to home but now Octoprint won't connect!
Error: volume.init failed

[AbuMaia]

Ah. When I disconnected the hotend module from the Toranado extruder while the printer was on, I thought it gave a maxtemp error due to the open circuit. I might have just misread the screen, though.

[tsteever]

What i have managed to find out is when the fans kick on the temp drops....and continues to drop. If I redirect the fans, the temp comes back up. This happens at all fan speeds.

I was using the new silicone sock but took it off cause it ripped on one of my failed prints. I am going to put on another one to see if that makes any difference. I did run a PID autotune with it on and the fans blowing. Should I run the PID with the fans off and sock off?