Subscribe to Our Newsletter Advertise
Close



Results 1 to 10 of 396

Threaded View

  1. 09-23-2016, 08:53 PM #10
    tsteever
    tsteever is offline
    Engineer-in-Training
    Join Date
    Feb 2015
    Posts
    371
    Man, not sure I should have opened this can of worms. It was working fine before.

    I went to check the servo angles and now it won't home. I am getting the following error...

    Error:MINTEMP triggered, system stopped! Heater_ID: 0
    Error:Printer halted. kill() called!

    10 minutes later and i can get it to home but now Octoprint won't connect!
    Error: volume.init failed
    Last edited by tsteever; 09-23-2016 at 09:26 PM.
    Reply With Quote Reply With Quote
« Previous Thread | Next Thread »

Tags for this Thread

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  

Forum Rules