Results 1 to 10 of 396
Threaded View
-
09-23-2016, 10:22 AM #11
- Join Date
- Feb 2015
- Posts
- 371
I am getting some inconsistent results. I have had about 50% fail rate since updating to the new firmware.
I think I have tracked my problem down to the ABL probe. It seems to over extend which results in a crash. I readjusted the extend and retract angles. I tested these by running a g28 and then a g29 and it worked. I shut down the printer.
The next day I ran a print and it failed. Looks like the ABL probe is using the old values even though the firmware has been updated with new values.
Ideas on where to start?
Qidi X Plus 3 Paper thin first...
05-27-2024, 01:15 AM in General 3D Printing Discussion