My left probe is 50. It is greater than 29.5.
Quote Originally Posted by dustmann View Post
Check your ABL probe positions, and make sure that your values will work within the parameters of your X/Y probe offset values. For example, your X probe offset from extruder looks to be 29.5, so your LEFT_PROBE_BED_POSITION should be > 29.5 or the probe will not be able to reach the indicated position (which would be on the other side of your Xmin endstop). Also, your Y probe is -1.3 so your BACK_PROBE_BED_POSITION should be less than your YMAX - 1.3.These are my settings as an example (and to show you the values of which I am referring):#if ENABLED(AUTO_BED_LEVELING_GRID) #define LEFT_PROBE_BED_POSITION 30 #define RIGHT_PROBE_BED_POSITION 260 #define FRONT_PROBE_BED_POSITION 0 #define BACK_PROBE_BED_POSITION 260#define X_PROBE_OFFSET_FROM_EXTRUDER 28 // X offset: -left +right [of the nozzle]#define Y_PROBE_OFFSET_FROM_EXTRUDER -20 // Y offset: -front +behind [the nozzle]#define Z_PROBE_OFFSET_FROM_EXTRUDER -4.14 // Z offset: -below +above [the nozzle]