Results 1 to 6 of 6
Threaded View
-
05-25-2024, 04:55 PM #3
- Join Date
- May 2024
- Posts
- 3
Thank you for the reply. Bed adhesion has been just fine. The first layer that is laid down is so thin I can see right through it. When I printed the flow rate calibration tablets in Orca Slicer, the numbers at the top were only one layer thick and transparent. I am sure it's a setting that I am missing somewhere. I will have to play with it more. I am new to Clipper firmware. I encountered another separate issue that required me reaching out to Qidi for a fix xo I have to wait on that first.
ABS Sticking to Build Plate
10-20-2024, 05:02 PM in 3D Printer Parts, Filament & Materials