Qidi X Plus 3 Paper thin first layer

[Bikeracer2020]

Thank you for the reply Bikeracer. Yes the X Plus 3 does have the Z offset option through the touch screen interface. When I set the printer up I used the calibration card as instructed until the print head "grabbed" the card and set my zero. When I get it back up and running I will take a look at the Z offset.

During a print, the 'Z' offset icon is on the information screen with all the temperature,speed and light icons etc. The option is not available until a print has been started.

Not to be confused with the initial 'Z' setting when leveling the bed, the 'Z' offset only affects the first layer.

Loads of Youtube videos on setting a first layer down.