Since the Pi-Top debuted back in September, it has already seen improvements and a successful Indiegogo crowdfunding campaign. Now, just a few months later, another remake of the 3D printable laptop is underway. Version 3 of the Pi-Top will see improvements in the laptop's functionality and design, including being 30% thinner than the already sleek Version 2. On the functionality side, a larger trackpad has been added, featuring integrated cantilever spring mouse buttons to allow for left- and right-clicking. These soon-to-be-released kits will run $299 with included Raspberry Pi board, or $264.99 without the board. Find out more about the updates in the full article: http://3dprint.com/45158/pi-top-version-3/


Below is a comparison with the smaller, sleeker Pi-Top next to a previous iteration: