Results 1 to 3 of 3
Hybrid View
-
05-11-2024, 08:34 AM #1
Took a quick look using google
found this hope it helps
Here
The code looks almost exactly like startup code on my Hictop 3DP11/12's.
My Hictop which is almost exactly the same as an Ender 3 with auto leveling works great with similar code.
My Startup G-code.
;Filament used: {filament_amount}m {filament_weight}g
;Filament cost: {filament_cost}
;M190 S{print_bed_temperature} ;Uncomment to add your own bed temperature line
;M109 S{print_temperature} ;Uncomment to add your own temperature line
G21 ;metric values
G90 ;absolute positioning
M82 ;set extruder to absolute mode
;M106 S127 ;set Fan half speed
M107 ;start with the fan off
G28 X0 Y0 ;move X/Y to min endstops
G28 Z0 ;move Z to min endstops
G1 Z15.0 F{travel_speed} ;move the platform down 15mm
;Put printing message on LCD screen
;M117 My Print...
G28 X0 Y0
G1 E4.0 ;prime extruder
G92 E0 ;reset extruder length
M420 S1 ; Bed Leveling On
M106 P1 S128 ; P1 = 2nd Fan
M220 S32.000000
;M420 V1 ; Print the leveling grid.
My End G-Code
M104 S0 ;extruder heater off
M140 S0 ;heated bed heater off (if you have it)
G91 ;relative mode
G1 Z+0.5 E-2 F{travel_speed} ;raise Z above print
G90 ;absolute mode
G1 X0 Y270 ;move extruder to rear left Model to front.
M84 ;steppers off
G90 ;absolute positioningLast edited by Roberts_Clif; 05-11-2024 at 08:46 AM.
ABS Sticking to Build Plate
10-20-2024, 05:02 PM in 3D Printer Parts, Filament & Materials