Results 1 to 8 of 8
Thread: Ender 3 Neo - Jam Problem
Hybrid View
-
05-06-2024, 05:48 PM #1
I have a similar 3D Printer and had a block so bad that decided to replace everything.
Throat w/PTFE throat
Heater Block
Nozzle
12/24volt Heater (as I have 12v and 24V 3D Printers)
Thermister
Then I had plenty of time to unblock --- I only did this once was so cheap to replace next time threw away anything that took too long to clean.
ABS Sticking to Build Plate
10-20-2024, 05:02 PM in 3D Printer Parts, Filament & Materials