Subscribe to Our Newsletter Advertise
Close



Results 1 to 6 of 6

Hybrid View

  1. 03-31-2024, 10:20 AM #1
    klopar
    klopar is offline
    Student
    Join Date
    Jun 2021
    Posts
    5
    I measured again the Z high (picture). I changed the nozzle and the tuba. It was the same print.
    z_hight.jpg
    Reply With Quote Reply With Quote
  2. 03-31-2024, 10:27 AM #2
    Bikeracer2020
    Bikeracer2020 is offline
    Super Moderator
    Join Date
    May 2020
    Posts
    622
    It's the 'Z' offset that needs adjusting not the 'Z' height.

    Have a look on Youtube for videos on adjusting it.

    You can adjust the "z" offset in Prusaslicer.
    Reply With Quote Reply With Quote
« Previous Thread | Next Thread »

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  

Forum Rules