Results 1 to 10 of 10
Threaded View
-
03-30-2024, 03:17 PM #7
- Join Date
- May 2020
- Posts
- 678
The whole STL looks odd to me.
Normally the STL would be just the actual wing I think, I can't see the point in printing the whole rectangle in several layers and then printing the wing profile on top of it because you then need to remove all the excess print rectangle afterwards.
Perhaps print a 25mm calibration cube and see if you can print the full height.
Check the printer profile to see if the figures in the cura configuration file for the X,Y and Z axis correspond to the build volume of the printer.
There does seem to be something not right in the STL, In Orca slicer it shows the first three layers as an alternating diagonal patterns as usual, then for the next several layers the extruder path just goes from corner to corner without actuall moving diagonaly over the print, also looking at each layer after the first three, the diagonal infil does not alternate, it's all in the same direction for each layer.Last edited by Bikeracer2020; 03-30-2024 at 03:33 PM.
ABS Sticking to Build Plate
10-20-2024, 05:02 PM in 3D Printer Parts, Filament & Materials