Close



Results 1 to 7 of 7
  1. #1

    Starts well, ends terribly

    Printing cable clips, looks good in the beginning but as it gets higher it goes from bad to worse, whats going on? Thanks.
    Attached Images Attached Images

  2. #2
    Super Moderator
    Join Date
    May 2020
    Posts
    607
    Just a suggestion.........

    Check your extruder 'e' steps and try ORCA slicer, it has some built in calibration files that you just have to print.

  3. #3
    Unfortunately my printer isnt listed in Orca.
    Last edited by Albertoinbox; 02-28-2024 at 02:40 AM.

  4. #4
    Super Moderator
    Join Date
    May 2020
    Posts
    607
    Which printer are you using?

  5. #5
    Flashforge Guider 2

  6. #6
    Super Moderator
    Join Date
    May 2020
    Posts
    607
    Perhaps manually transfer the settings from your current slicer into ORCA slicer as a start. bit tedious, but one way to make your own slicer profile.

    Also look on YouTube for over and under extrusion problem videos

  7. #7
    Thanks for the help

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •