Subscribe to Our Newsletter Advertise
Close



Results 1 to 9 of 9

Threaded View

  1. 01-10-2024, 02:27 AM #2
    Bikeracer2020
    Bikeracer2020 is offline
    Super Moderator
    Join Date
    May 2020
    Posts
    622
    The 'Z' offset you've set at -0.15 is nearly a full 0.2 layer height. usually set mine to between 0.0 and +0.02
    Which of the two extruders are you using, the normal one or the high temp one?
    Last edited by Bikeracer2020; 01-10-2024 at 05:07 AM.
    Reply With Quote Reply With Quote
« Previous Thread | Next Thread »

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  

Forum Rules